Replacing a torsion garage door spring can be intimidating, but with the right information and know-how, it doesn’t have to be. Before tackling this project on your own, however, it is important to first measure your existing torsion spring to ensure you purchase the correct replacement. This guide will walk you through the steps you need to take to accurately measure your torsion garage door spring Glen Allen.
Before you start, make sure you have a measuring tape and a few other simple tools, such as a pencil, wrench, and screwdriver. It is also important to wear safety goggles in case of flying parts or pieces during the measuring process.
Now that you have all the necessary tools, it’s time to measure your torsion spring. The first step is to identify the two parts of the torsion spring system: the stationary cone and the winding cone. The stationary cone is located at the centre line of your garage door and remains fixed throughout the measuring process. The winding cone is located at the end of the spring and will move when you adjust or measure it.
Once you have identified both cones, use your tape measure from the centre line of your garage door to the winding cone. This measurement is important because it will help determine if you need to order a left-wound or right-wound torsion spring replacement. Now measure the length of the stationary cone, starting from where the spring wraps around it and ending at the tip of the cone. Finally, measure the diameter of your torsion spring by wrapping your tape measure around its coils from end to end.